Table of Contents Toggle FeatureSensitivityInterface Defines Two-way wireless transmission digital data link module Drone Dual wireless video data transceiver link module DIY your own transmitter and receiver Feature COFDM two-way wireless transmission link module Wireless pass-through Ethernet ports and 1 wireless pass-through TTL serial port Dual antenna transmit and receive, MIMO mode of operation Support wireless frequency band: 2401.5~2481.5MHz, 1427.9~1447.9MHz, 806~826MHz, support automatic frequency hopping in the frequency band Wireless bandwidth configurable: 1.4MHz, 3MHz, 5MHz, 10MHz, 20MHz, the maximum air interface rate can be matched to 30Mbps Modulation method: QPSK/QAM16/QAM64 automatic adaptation Maximum transmission power: 25±2dBm Support wireless link encryption and decryption Supports point-to-point and point-to-multipoint communication. Up to 16 access nodes can be connected to one central node. Sensitivity Frequency Band 2.4GHz(1Mbps) 1.4GHz(1Mbps) 800MHz(1mbps) 20Mhz Bandwidth -99dBm / / 10Mhz Bandwidth -102dBm -103dBm -103dBm 5Mhz Bandwidth -104dBm -106dBm -106dBm 3Mhz Bandwidth -106dBm -108dBm -108dBm Interface Defines Ethernet-1: two-way wireless transparent transmission network port, 4PIN 1.25mm pitch with a buckle carrier Ethernet-2: two-way wireless transparent transmission network port, 4PIN 1.25mm pitch carrier or direct 4PIN soldering hole Data-UART: bidirectional transparent data serial port, TTL 3.3V level, 3PIN 1.25mm pitch with a snap carrier Main Antenna: main antenna interface, IPEX carrier Second Antenna: Auxiliary antenna interface, IPEX carrier. The auxiliary antenna can only be received. When the DLM module is used for communication, it can be double-received or received. Power: Power input interface, support 7~24V wide voltage input, maximum power consumption is less than 3.5W. USB: 4PIN 1.25mm pitch carrier, not yet open to users. Config UART: 4PIN 1.25mm pitch carrier, not yet open to users. The DLM module measures 58x48mm (excluding the dimensions of the interface device extending from the edge of the board), the front device height is less than 3.2mm, the back device height is less than 4.5mm, the board thickness is 1.6mm, and the weight is 31.5g. Power Supply The power supply signal is shown in the figure above. The power input is 2 solder holes and supports 7~24V wide voltage input. 4V power supply is provided externally for power supply of cooling fan. Ethernet and Data Signal Indicator Ethernet-1 LED: Green, a signal indicator on the network port. The network port will flash when transmitting data normally. Ethernet-2 LED: Green, network port two signal indicator, the network port will flash when transmitting data normally. Power LED: red, always on when power is normal Link LED: The working status indicator of the wireless link. When the module works as a slave node, if the wireless connection with the master node is normal, the indicator will be on. This indicator is invalid when the module is working as the master node. Two-way wireless transmission digital data link module We can customize the housing for you to create a unique brand for you, and we can also add additional amplifiers to allow for longer transmission distances. Two-way wireless transmission digital data link china Two-way wireless transmission digital data link morningcore Two-way wireless transmission digital data link drone